Replacing The Cd-Rom Audio Cable - Sun Microsystems SPARCstation 5 Service Manual

See Figure 9–27.
Figure 9–27 CD-ROM Audio Connector on the System Board
5. Carefully note how the CD-ROM audio cable is routed, and remove it from the
system chassis.

Replacing the CD-ROM Audio Cable

1. Route the replacement cable in the same manner as the defective cable that you
just removed.
Secure the cable beneath the plastic cable clips on the card guide. See Figure 9–27.
2. Connect the CD-ROM audio cable to the system board.
See Figure 9–27.
3. Connect the CD-ROM audio cable to the audio connector on the
CD-ROM drive.
95
Storage Devices