Replacing An Sbus Card - Sun Microsystems SPARCstation 5 Service Manual

Figure 11–6 Removing a Double-Width SBus Card
7. Remove the card extractor from the SBus card:
a. Bend one leg of the extractor slightly to the outside until the hook clears the
hole in the SBus card.
See Figure 11–5.
b. Remove the other side of the extractor, which should come out easily
without bending.
8. Place the faulty SBus card on an antistatic surface.
Do not confuse it with the replacement card.

Replacing an SBus Card

1. If required for your card, set the jumpers or switches on the replacement card.
See the manual for your SBus product.
2. Push back the two card retainers on the SBus connector (if necessary).
See Figure 11–6.
System Board and Component Replacement
105