Sun Microsystems SPARCstation 5 Service Manual page 98

Figure 9–16
2. Secure the SCSI data cable under the plastic card guide cable clips.
3. Connect the SCSI data cable to the SCSI backplane.
4. Connect the DC power harness to the SCSI backplane.
5. Insert the front edge of the system board into the card guide. Lift the rear of
the board slightly and slide it along the card guide until it is fully inserted.
See Figure 9–17.
SPARCstation 5 Service Manual ♦ Revision A, August 1994
84
Internal Cable Routing