GME GA9800 Instruction Manual page 82

CLoNING SToRED MEMoRIES WITh ANoThER UNIT
The memories stored in your receiver
can be transferred to or from another
RX1300 receiver. To perform this
function you will need a cloning cable
(available separately).
Cloning is performed as follows:
1. Place the two receivers side by side
and connect the cloning cable as
shown in the diagram below.
2. Switch both radios on as follows;
a. On the MASTER unit (the receiver
you are copying from) press and
hold the FUNC and MODE keys
while turning the unit On. The radio
will display CLON TX
b. On the SLAVE unit (the receiver
you are copying to) press and hold
the FUNC and MODE keys while
turning the unit On. The radio will
display CLON TX. Rotate the knob
to display CLON RX.
RX1300
PAG E 2 2
3. To begin cloning, press the E/VFO key
on BOTH radios.
4. DATA TX is displayed on both radios
and the radio beeps as each memory
bank is cloned.
5. When cloning is completed both
radios display CLON OK.
6. If cloning fails, FAIL will be displayed
on the MASTER radio. To try again,
repeat step 3.
If repeated cloning attempts fail, repeat
the entire procedure from step 1.
Once cloning has completed successfully,
switch both radios off and remove the
cloning cable. You can now switch the
cloned (SLAVE) radio on and access the
frequencies you have transferred.
I N S T RUC T I O N MANUAL
RX1300
RX1300