GME GA9800 Instruction Manual page 279

To disable dCS on the Radio:
1. S elect a DCS enabled channel using the
or keys. The DCS code will be displayed on
that channel.
2. Press and hold the SQL key for about 2
seconds. The 'DCS' icon and DCS code will
disappear from the display indicating DCS is
no longer activated.
Note: DCS is only enabled on those channels
with DCS codes selected. All other channels will
continue to operate normally.
3. Transmitter power
The transmitter power can be set to High (5
Watts) or Low (1 Watt). The power setting
applies to all channels
To set the transmit power:
From the Standby mode;
1. Press the MOde key THREE (3) times to
select the power setting mode. 'Po' will be
displayed and 'HI' or 'LO' will be flashing on
the display.
2. Press the or keys to select the required
power setting. Select HI for high power or
LO for low power.
3. Press and hold the MOde key (or press the
pTT key momentarily) to confirm and store
your selection.
The TX6100 should now display the selected
channel number along with 'HI' or 'LO' to
indicate the transmit power you have set.
4. VOX Settings
The VOX feature lets you have handsfree
conversations. When you speak, the microphone
automatically detects your voice (or other
nearby sound) causing the radio to transmit
without the need to press the pTT switch.
To set radio for VOX operation:
From the Standby mode;
1. Press the MOde key FOUR (4) times to
select the VOX setting mode. will flash
PAGE 10
on the display.
2. Press the
the sensitivity from 1 (minimum) to 7
(maximum). The minimum setting requires
a louder voice to activate the VOX. The
maximum setting will activate the VOX with
a much softer voice.
3. To disable the VOX completely, set the VOX
sensitivity to off.
4. Press and hold the MOde key (or press the
pTT key momentarily) to confirm and store
your selection. When the VOX is enabled,
'VOX' is visible on the display.
5. dual Watch Settings
The Dual Watch mode lets you to monitor two
channels at the same time. While in dual watch
mode, the unit will monitor both the currently
selected channel and a second dual
watch channel.
To set the dual Watch Mode:
From the Standby mode;
1. Press the MOde key FIVE (5) times to select
the Dual Watch setting mode. The
will flash on the display.
2. Press the
Watch channel number (1 – 40). To disable
the Dual Watch Mode altogether select off.
3. Press and hold the MOde key (or press
the pTT key momentarily) to confirm and
store your Dual Watch channel selection.
and the display will now alternate between
the currently selected channel and the Dual
Watch channel.
To eXIT the dual Watch mode:
Momentarily press the SCAN key. This is
equivalent to setting the DW mode to off.
dual Watch Operation:
• I f a signal is received on the Dual Watch
channel, the radio will pause on that channel
for as long as it remains busy, then resume
the Dual Watch 5 seconds after the last
transmission has ceased.
I N S TRU CT I ON M A N UA L
or keys to select
or keys to select the Dual
will be displayed at the top of the LCD
icon
TX 6100