Full Search; Limited Search - GME GA9800 Instruction Manual

4. Select a start frequency to search
from. To do this, enter the frequency
on the keypad, then press E/VFO key.
5. Press the SCAN SRC key briefly. The
'SRCH' icon will be displayed and the
receiver will search the selected band
starting from the start frequency.
Once the end of the band is reached
the search continues at the beginning
of the selected band.
6. To stop the search, press the SCAN
SRC key again.
• During the search, press the BANK
BAND key to move to the next band.
• T o change the search direction
rotate the control knob clockwise or
counter clockwise.
• T he receiver will stay on an active
channel according to the Scan Timer
settings in the VFO Menu. If the
Scan Timer is set to '5 seconds',
the receiver will continue searching
after 5 seconds even if the channel
is still busy. If the Scan Timer is set
to 'Busy', the receiver will remain on
the busy frequency for as long as it
stays busy, then resume searching
when the signal disappears.

Full Search

The Full Search function searches the
entire scanner frequency range
for signals.
1. Press the E/VFO key to select
VFO Mode. (Note: the receiver
automatically selects the VFO Mode
when it is turned on).
PAG E 1 2
2. Set the Squelch level using the
Squelch keys so that the noise
just disappears.
3. Press and hold the SCAN SRC key
for 2 seconds. The 'SRCH' icon will
be displayed and the receiver will
search the entire frequency range of
the receiver.
4. To stop the search, press the SCAN
SRC key again.
• D uring the search, press the BANK
BAND key to move to the next Band.
• T o change the search direction rotate
the control knob clockwise or counter
clockwise.
• T he receiver will stay on an active
channel according to the Scan Timer
settings in the VFO Menu. If the
Scan Timer is set to '5 seconds', the
receiver will continue searching after
5 seconds even if the channel is still
busy. If the Scan Timer is set to 'Busy',
the receiver will remain on the busy
frequency for as long as it stays busy,
then resume searching when the
signal disappears.

LIMITED SEARCh

You can limit the search between two
user-selectable frequency limits.
1. Press the E/VFO key to select
VFO Mode. (Note: the receiver
automatically selects the VFO Mode
when it is turned on).
I N S T RUC T I O N MANUAL RX1300