Charging The Battery Pack - GME GA9800 Instruction Manual

pOWeRINg THe RAdIO
Your TX680 is powered by a 7.4 Volt 1000
mAh Li-Ion battery pack. When the battery
pack is new, it should be fully charged before
being used for the first time. If left unused,
your TX680's battery pack will discharge itself
within a few months . If you have not used
your TX680 for some time, you will need to
recharge the battery pack before use.
WARNING: Use only the approved GME
charger. The use of other types may be
dangerous and will void the warranty .
fitting the Battery pack
To fit the battery pack:
1. L ocate the bottom of the battery pack
into the two slots in the base of the
radio frame .
2. P ress the top of the battery pack in to
place against the radio until it 'clicks' .
To Remove the Battery pack
1. S lide the battery retaining clip downward
while pulling the top of the battery away
from the radio .
2. L ift the battery pack upward to clear the
slots at the bottom of the radio.

Charging the Battery pack

Your TX680 is supplied with an AC adaptor
and a Semi-quick charger .
The charger will charge a fully discharged
1000 mAh battery pack to full capacity in
around 3-4 hours .
1 . Plug the charger into a standard 240 Volt
AC outlet .
TX680
Slide
Downwards
Swing
Away
INSTRUCTION MANUAL
2 . Plug the lead from the charger into the
charging cradle .
3 . Place the TX680 into the cradle . The Red
LED will light to indicate the battery
is charging .
4. W hen the battery has charged, the LED
will change to Green .
To Remove Battery pack
To Refit Battery pack
Press
Battery Low Alert
When the battery icon blinks on the display,
the battery level is low and the battery pack
should be recharged. If the battery is not
charged, an audio tone will then sound to
warn the user that the battery is
almost discharged .
Slide
Downwards
Swing
Away
Press
Page 5