Disabling A Receive-Only Channel; Scanning On Receive-Only Channels; Receiving Selcalls On Your Receive-Only Channels; Ctcss - GME GA9800 Instruction Manual

DISABLING A RECEIVE-ONLY CHANNEL

If you no longer wish to display a Receive-Only channel, you can switch it off so the channel
number no longer appears when selecting channels.
1. Select the receive-only channel that you wish to disable.
2. Press and hold the F key for about 2 seconds until the radio beeps. The frequency stored in
that channel will be displayed.
3. Briefly press the CALL key to select the MHz frequency stepping mode. This will allow faster
frequency changing.
4. Press and HOLD the
5. Press and hold the F key to store the new setting.

SCANNING ON RECEIVE-ONLY CHANNELS

The additional receive channels can be programmed into your scan groups in the same way as
your normal CB channels. Simply select the required receive-only channel, select the required
scan group (Open or Group Scan), then press and hold the SCAN key until the radio beeps.
"M" will be displayed on that channel to indicate that it is in the scan memory. For more details,
see the section on 'Scanning' in this manual.

RECEIVING SELCALLS ON YOUR RECEIVE-ONLY CHANNELS

If your TX6200 receives its Selcall code on a Receive-Only channel, it will respond in the usual
way, except that it cannot automatically transmit two quick beeps back to the caller since there
is no transmit frequency. For more details, see the section on 'Selcall' in this manual.

CTCSS

CTCSS can be enabled on the Receive-Only channels.
TX6200
key to step down through the frequencies until -OFF- is displayed.
User Instructions Page 37