Entering, Storing And Sending Selcalls; Call Acknowledge - GME GA9800 Instruction Manual

ENTERING, STORING AND SENDING SELCALLS

ENTER AND SEND A SELCALL
Use the following procedure to enter and send a Selcall.
1. Press the CALL key. 'CALL TO' is displayed, along with the last sent or received Selcall
Ident.
'CALL TO' mode selected
Note: Before continuing, ensure the radio is in the Ident mode. Idents cannot be entered if
the radio is in Alpha mode. To toggle between Alpha mode and Ident mode, briefly press the
Monitor key. A high beep indicates Alpha mode is selected while a low beep means the Ident
mode is selected.
2. Enter the required Selcall ident as follows:
(a) Briefly press the F key. The right-hand digit of the Selcall Ident will flash.
(b) Press the
(c) Briefly press the F key again to select the next digit position.
(d) Repeat steps (b) and (c) to enter all 5 digits as required.
3. Now press and hold the CALL key to send the Ident.

CALL ACKNOWLEDGE

If your Selcall transmission is successful, the radio you called should respond with a 'call
acknowledge' signal - usually two quick beeps. This will confirm to you that the radio you
called is now alerting its user to your signal.
TX6200
or channel keys to select the required number in the flashing digit position.
User Instructions
last sent or
received selcall Ident
Page 19