Memory Keys; Automatic Memory Storage - GME GA9800 Instruction Manual

memory Keys

The GR200 has 6 preset memory keys which allow up to 6 frequencies to be stored and
recalled within each band . Because there are two identical AM bands and two identical
FM bands, this allows 12 AM and 12 FM preset memories . The memories can be stored
either manually or automatically .
manually locating and storing station frequencies in the preset memories
1 . Press the Band key repeatedly until the required band is selected .
2 . Press the mode key repeatedly until the frequency adjustment mode is selected
('FReQ' will be displayed) .
3 . Press the or
automatically scan for the next station, press and hold the
4 . Once the required station has been located, press and hold one of the six memory
keys for 3 seconds . The frequency will flash and the sound will mute briefly as the
frequency is stored into the selected memory . The selected memory number will be
displayed at the top of the LCD .
Repeat steps 3 and 4 above to store other frequencies into the preset memories .
Note: If a frequency or VHF marine channel is selected that is already stored in memory,
the allocated memory number will also be displayed .
recalling stations from the preset memories
Select the required band, then briefly press the required memory button . The GR200 will
switch to the frequency stored in that memory location and the selected memory number
will be displayed at the top of the LCD .
automatIc memory storaGe (ams)
The AMS feature allows the GR200 to search the selected band for stations and
automatically store the first six strongest stations it locates into the station memories .
While activated, the Local (LOC) receiver sensitivity mode is temporarily enabled to ensure
only stronger local stations are selected .
To activate the AMS feature, briefly press the mode key repeatedly until 'AMS' is
displayed on the lower right of the LCD . To begin the search, press the
Pressing the key will cause the GR200 to search upwards through the frequencies
while pressing the
the last displayed frequency . As strong stations are found they will be automatically stored
into the station memories . When all six memories have been filled, or the entire band has
been searched, the search will stop and the station in Memory 1 will be selected .
To manually stop the memory search, briefly press the
direction, briefly press the opposite key after the search has been
manually stopped .
GR200
key briefly to manually step through the frequencies . To
key will cause it to search downwards . The search will begin from
I NS T RUC T ION M A NUA L
or key .
or
or key . To change the search
key .
Page 9