Storing Selcall Idents; Recalling Selcall Idents From The Memory - GME GA9800 Instruction Manual

STORING SELCALL IDENTS

Your TX6200 is fitted with 10 user programmable Selcall Ident memories, allowing you to store
up to 10 frequently used Selcall Idents. The memories are accessed by pressing the CALL key
then pressing the
To Store a Selcall Ident in memory
1. Press the CALL key to select the "CALL TO" mode. "CALL TO" is displayed along with
the last sent or received Selcall Ident.
2. Press the or
(locations c0 to c9).
TIP: If the radio displays letters instead of numbers in the Selcall Ident position, your radio is
in ALPHA mode. To switch back to Ident mode, briefly press the MONITOR key. A low beep
should be heard indicating Ident mode is now selected.
3. With the required memory location displayed, enter the Selcall ident as follows:
(a) Briefly press the F key. The right-hand digit of the Selcall Ident will flash.
(b) Press the
(c) Briefly press the F key again to select the next digit position.
(d) Repeat steps (b) and (c) to enter all 5 digits as required.
(e) Now press and hold the F key. The entire Ident will flash for a few seconds then the
radio will beep as the new Ident is stored.

RECALLING SELCALL IDENTS FROM THE MEMORY

1. Press the CALL key to select the "CALL TO" mode. "CALL TO" is displayed along with
the last sent or received Selcall Ident.
2. Press the or
(locations c0 to c9).
3. When the required Selcall memory is displayed, press and hold the CALL key to send the Ident.
Page 20
or channel keys. Ident memories are labelled c0 to c9.
channel keys to select the Ident memory that you wish to programme
or channel key to select the required number in the flashing digit position.
channel keys to select the Ident memory that you wish to recall
User Instructions TX6200