GME GA9800 Instruction Manual page 130

connecting the microphone
the microphone uses a 6 pin plug and socket.
to connect the microphone:
1. Position the microphone plug in the socket so the plastic tab
faces away from the speaker, and press the plug into the socket
until it 'clicks'.
2. Gently slide the rubber boat towards the hole surrounding the
socket and press into place until it locks into the front panel.
Flipping the Display
the tX3310's small size allows it to be mounted in almost any convenient location. However the most suitable location may sometimes
require the unit to be installed upside-down when referenced to your driving position.
the tX3100 is designed to overcome this situation by allowing the display to be 'flipped'. In addition the keys have symbols that can be
read from either direction.
you can flip the display as follows.
With the unit installed or held in the required orientation;
1. turn the unit off.
2. Press and hold the key while turning
the radio on.
3. the display will be flip to match the
radio's orientation.
PA G E 1 0
removing the microphone
1. Slide the rubber boat back along the microphone cord.
2. Squeeze the plastic tab on the microphone plug towards the
Speaker
Plastic tab
TX3100
i n s t r u c t i o n m A n u A l
plug to unlock it while gently pulling the plug outwards. If the
plug does not come out easily, the tab has not released correctly
and should be squeezed again.
Cable
Front Panel Upright (speaker above)
Front Panel Flipped (speaker below)
Screwdriver
Locking Lever
move to left to
release Plug
Cable entry hole
TX3100
S
t X 3 1 0 0