Mounting The Gr200 - GME GA9800 Instruction Manual

mouNtING tHe Gr200

The GR200 is designed to be mounted in several different ways to enable it to be
installed in the most convenient position . The GR200 is designed to meet IP55 Standard
(
Refer: www .gme .net .au/IPRatings
viewing angle for the display . For best results select a location that is free from excessive
vibration and continuous direct sunlight .
Panel Mount
upright or overhead mounting
Position the mounting bracket onto the GR200 so that the mounting holes in the bracket
align with those on the side of the unit, and fit the gimbal knobs . Temporarily position
the bracket in the desired location and roughly mark the bracket edges . Now remove the
unit from the bracket and reposition the bracket to mark the mounting holes . Screw or
bolt the bracket into position . The mounting method will depend on the surface to which
the bracket is being attached . Refit the GR200 to the bracket and adjust the unit to the
correct position before tightening the gimbal knobs .
Complete the antenna lead and electrical wiring as described later .
Flush mounting
If you require to flush mount your GR200 we recommend the MK100 flush mounting kit
designed especially for the purpose . Instructions and a mounting template are included
with the kit .
GR200
) . A location should be selected which provides the best
Overhead Mount
Panel
Bracket
I NS T RUC T ION M A NUA L
Upright Mount
GR200
Page 11