GME GA9800 Instruction Manual page 241

FITTING THE MICROPHONE
The microphone uses a miniature 6 pin telephone style plug
and socket .
To fit the microphone:
1 . P osition the microphone plug so the plastic tab faces
downwards . Press the plug into the socket until
it 'clicks' .
2 . G ently press the rubber strain relief into the hole
surrounding the socket so that the slot around the strain
relief fits neatly inside the lip of the hole .
Removing the microphone .
1 . S queeze the rubber strain relief near the front panel to
disengage the slot, and slide the strain relief back along
the microphone cord .
2 . P ress the small plastic tab on the microphone plug
towards the plug to unlock it, while gently pulling the
plug outwards . If the plug does not come out easily, the
tab has not released correctly and should be pressed
again . You may need a small bladed screwdriver for this
task, as the tab can be difficult to reach with
your fingers .
Cable
Lift locking tab
to release plug
REAR MICROPHONE CONNECTION
TX4400M
The TX4400M comes with the LEM6M rear accessory pack
factory fitted .
To fit the rear mounting microphone optional
accessory kit (LEM6M):
1 . R emove the 4 screws from the rear panel securing the
cover and slide the cover from the radio (figure 1) .
Figure 1
PAG E 2 0
2 . T urn the TX4400 upside down, remove the black
Figure 2
Figure 3
Microphone plug
Rear
microphone
socket
3 . S ecure the rear microphone printed circuit board
4 . C onnect the 6 pin lead attached to the rear microphone
5 . R efit the cover and fasten with the 4 screws
Microphone Extension Lead
The LEM6P is a 4 metre microphone extension lead that can
be fitted to the microphone socket .
I NST RUC TIO N M AN UAL
grommet from the back of the radio and insert into the
front panel microphone socket aperture of the TX4400
(figure 2) .
(PCB) supplied with the LEM6M accessory kit with
the screws provided (Figure 3) .
PCB and the 6 pin socket on the front PCB .
Rear microphone PCB
Connection
to front
PCB
T X4 4 00