To Activate The Ctcss Function On A Channel - GME GA9800 Instruction Manual

TO ACTIVATE THE CTCSS FUNCTION ON A CHANNEL

The selected CTCSS tone can be activated on individual channels. To activate CTCSS on a
channel:
1. Press the or
2. Press and HOLD the Monitor key. A high beep will be heard and the 'SILENT' icon will
appear on the display.
Note: You may activate CTCSS on as many channels as you wish except the emergency
channel 5/35.
To de-activate CTCSS on a channel, repeat steps 1 & 2 above. A low beep will be heard and
'SILENT' will disappear.
Note: You will not be able to activate CTCSS if the CTCSS tone is set to oF.
Tip: If you wish to identify which CTCSS tone is being used by stations on a particular
frequency, simply enable CTCSS on that channel (so that SILENT is displayed) then use the
process desribed under 'Selecting the required CTCSS tone' to step through the range of
available CTCSS tones while the the channel is busy. When the correct tone is selected, you
will be able to hear the signal in the speaker.
Page 30
key to select the required channel.
User Instructions
CTCSS is activated
on this channel
TX6200