2. Transmitter Power; 3. Vox Settings - GME GA9800 Instruction Manual

MODE
4. Press the
store your selection.
note: CTCSS is only enabled on those channels with CTCSS
codes selected. All other channels will continue to
operate normally.

2. Transmitter Power

The transmitter power can be set to High (2 Watts) or Low
(1 Watt). The power setting applies to all channels.
To set the Transmit Power
From the 'Standby' mode:
MODE
1. Press the
mode. 'Po' will be displayed and 'HI' or 'LO' will be flashing
on the display.
2. Press the
Select 'HI' for high power or 'LO' for low power.
MODE
3. Press the
store your selection.
The TX670 should now display the selected channel number
along with 'HI' if you have selected high power. If you have
selected low power, this setting will not be indicated.

3. VOX Settings

The VOX feature lets you have hands-free conversations. When
you speak, the microphone automatically detects your voice (or
other nearby sound) causing the radio to transmit without the
need to press the PTT switch.
To set radio for VOX operation
From the 'Standby' mode:
MODE
1 Press the
setting mode. 'VOX' will flash on the display.
2. Press the
(minimum) to 3 (maximum). The minimum setting requires a
TX670
PTT
or key momentarily to confirm and
key TWICE (2) to select the power setting
or keys to select the required power setting.
PTT
or key momentarily to confirm and
key THREE (3) times to select the VOX
or keys to select the sensitivity from 1
Instruction Manual Page 13