GME GA9800 Instruction Manual page 298

SELECTING A SCAN GROUP
The current scan group is shown on the display as 'OS' for Open Scan or 'GS' for Group Scan.
To change the selected scan group, briefly press the F key followed immediately by the
OS/GS key. A beep will be heard and the display will change to reflect the scan group you have
selected.
PROGRAMMING SCAN CHANNELS
Your TX6200 is supplied with all 40 UHF CB channels programmed into the Open Scan
memory. Any channels not needed can be removed if required. The Group Scan memory is
empty by default and you will need to add channels to it before use.
To add or remove channels from either scan memory:
1. Check that the radio is not already scanning. If it is, briefly press the SCAN key to cancel the
scan function.
2. Select the required scan group by pressing the F key followed immediately by the OS/GS
key. A beep will be heard and the display will change to reflect the scan group you have
selected.
3. Select the required channel by pressing the
• If "M" is visible to the right of the channel number, the selected channel is already in the
scan memory. It can be removed by holding the SCAN key in for a few seconds until a
low beep is heard. "M" will then disappear indicating the channel is no longer in memory.
• If "M" is not visible, then the selected channel is not in the memory. To add it, hold the
SCAN key in for a few seconds until a high beep is heard. "M" will now appear.
4. Repeat step 3 to add or remove other channels in the scan memory.
TX6200
Open Scan
Selected
or channel selector keys.
User Instructions
Group Scan
Selected
Page 13