GME GA9800 Instruction Manual page 90

To amp
or stereo
S PK 01 1
MOUnTIng InSTRUCTIOnS
PReCAUTIOnS
Please avoid contact with inside speaker wire A.
Do not change the polarity of the speaker terminal assembly B.
Make sure lead and speaker terminals do not contact metal.
When making connections, please refer to the instruction manual of
stereo used.
COnneCTIng
1. Attach the speaker wires (supplied) to the speaker terminals, be
sure to connect the correct spade connector to the correct size
terminal.
2. Connect the other end of the speaker wires to your amplifier/
stereo ensuring '+' goes to '+' and '–' goes to '–'.
MOUnTIng
1. When mounting the SPK011, make sure there is a clearance of
50 mm (2") behind the well.
2. Push out the template from this leaflet and use to mark the
position of the mounting screws and the outline of the speaker
hole. Drill the mounting holes and cut the hole for the speaker.
3. Push speaker mesh out from its frame.
4. Place speaker in hole, slot frame over speaker, and using fixings
supplied fix speaker into place.
5. Push the mesh back into the frame.
SPeAKeR dRIveR SPeCIfICATIOnS
System Coaxial speaker
Power (Watts) 110
Tweeter - mm (inches) 13.28 mm (½) Mylar Dome
efficiency (1W/1 M)
83 dB
frequency Response 100 Hz–20 kHz
Impedance (Ohms) 4
Weight - gms (lbs) 525 g (1.16 lb)
STAndARd COMMUnICATIOnS
COnTRACT WARRAnTy
1. STATUTORy WARRAnTIeS
1.1 The Trade Practices Act Part V, Division 2A and other
legislation imply conditions, warranties and other
obligations on us to consumers that cannot be
excluded, restricted or modified. Those provisions apply
to the extent required by law.
1.2 We exclude all other conditions, warranties and
obligations which would otherwise be implied
concerning the activities covered by this agreement.
1.3 We limit our liability where we are allowed to do so.
Examples of where we are allowed to limit liability are -
(a) you acquire goods from us for re-supply;
(b) the goods or services we supply are not of a
kind ordinarily acquired for personal, domestic or
household use or consumption.
1.4 Where we are allowed to limit our liability, to the
extent permitted by law, our sole liability for breach of
a condition, warranty or other obligation implied by law
is limited -
(a) in the case of goods we supply, to any one of the
following as we decide -
(i) the replacement of the goods or the supply of .
equivalent goods;
(ii) the repair of the goods;
(iii) the payment of the cost of repairing the goods
or of acquiring equivalent goods;
(iv) the payment of the cost of having the goods
repaired; or
(b) in the case of services we supply, to any one of the
following as we decide -
(i) the supplying of the services again;
(ii) the payment of the cost of having the services
supplied again.
2. AddITIOnAL WARRAnTIeS
2.1 The warranties in this clause are in addition to the
statutory warranties referred to in the previous clause.
2.2 We warrant our goods to be free from defects in
materials and workmanship for one year from the
date of original sale (or another period we agree to in
writing). During this period and as our sole liability to
TECH NICA L SPECIFIC ATION A ND CU TTING TEM PLATE