Lcd Contrast - GME GA9800 Instruction Manual

CTCSS Tone Number Displayed
CTCSS Tone frequency Displayed
4. To turn CTCSS tones Off select CTCof
5. Press and hold the MENU key until the radio beeps,
to store the setting
lAMP COlOUR
The display lamp can be set to Orange, Red or Green to
match other equipment you might have installed or to
satisfy personal preference
1. Press and hold the MENU key until the radio beeps.
2. Briefly press the MENU key repeatedly until 'LAMP'
is displayed.
3. Press the or keys to cycle through the available
colours of Orange, Red or Green.
4. Press and hold the MENU key until the radio beeps,
to store the setting
BATTERY/S-METER/AlPHA SElECTION
The TX4600 has the option of displaying either the battery
voltage or the incoming signal strength (S-meter) in the area
beneath the channel display. In addition, when 'Listening'
channels (41 – 80) are selected, the radio provides an extra
option of displaying the frequency of the selected user
channel or a custom ALPhA label (when ALPhA mode
is selected).
The 'Listening' channels are treated independently to the
normal Uhf CB channels in that you can for example,
select S-Meter or Battery voltage on Channels 1 - 40
yet display the channel frequency (or an ALPhA label)
on channels 41 – 80.
PAG E 1 8
To display S-Meter or Battery Voltage
on channels 1 - 40:
1. Select a channel from 1 – 40.
2. Press and hold the MENU key until the radio beeps.
3. Briefly press the MENU key repeatedly until 'S-MET'
(S Meter) or 'bATT' (Battery) is displayed.
4. Press the
S-MET and bATT.
5. Press and hold the MENU key until the radio beeps, to
store the setting.
To display S-Meter, Battery voltage or frequency/Alpha label
on 'Listening' channels (41 – 80):
1. Select a channel from 41 – 80.
2. Press and hold the MENU key until the radio beeps.
3. Briefly press the MENU key repeatedly until 'S-MET'
(S Meter), 'bATT' (Battery) or 'ALPhA' is displayed.
4. Press the
S-MET (S Meter), bATT (Battery) or ALPhA.
5. Press and hold the MENU key until the radio beeps, to
store the setting.

lCD CONTRAST

Use this setting to adjust the LCD display contrast.
To adjust the contrast:
Note: Adjusting the contrast may affect the viewing angle.
1. Press and hold the MENU key until the radio beeps.
2. Briefly press the MENU key repeatedly until 'LCDXX' is
displayed (where XX is a number from 0 to 15).
IN ST RU C TIO N MAN UAL
or keys to select your preferred choice of
or keys to select your preferred choice of
TX 4 60 0