Install Memory (Simm); Remove The Mpcb (Main Printed Circuit Board) - ENCAD CADJET Service Manual

CadJet 3D Service Manual

Install Memory (SIMM)

1. The SIMM slots are at a 90° angle from the board. Place the SIMM
at a 45° into the connector as shown in Figure 5-5.
2. Slowly push the SIMM up to a 90° angle until the two side clips
snap into place. Make sure the SIMM is fully seated.
3. Perform steps 4 through 10 of the Install the Left, Top, and Right
Covers procedure to install the Right and Top Covers.

Remove the MPCB (Main Printed Circuit Board)

1. Perform steps 1 through 9 of the Remove the Left, Top, and Right
Covers procedure to remove the Top and Right Covers.
2. Put on an ESD wrist strap.
3. Perform step 2 of the Remove Memory (SIMM) procedure to remove
any memory that was added.
5-10 Assembly\Disassembly
If you are installing two SIMM, you must install the one
located in J17 first. See Figure 3-4 for location.
Integrated circuits may become weakened or damaged by
electrical discharge. Do not touch or work near integrated
circuits without wearing an ESD wrist strap.
NOTE