Control Module For Headlamp Range/Cornering Lamp And Headlamp Range, Removing And Installing - Volkswagen Golf 2015 Repair Manual

11.2 Control Module for Headlamp Range/
Cornering Lamp and Headlamp Range,
Removing and Installing
If the control module is being replaced, use the Vehicle Diagnostic
Tester and select the "Replacing" function for the respective con‐
trol module in "Guided Fault Finding".
Removing
– Turn off the ignition and all electrical equipment.
– Remove the ignition key, if equipped.
– Remove the driver side instrument panel cover. Refer to ⇒
Body Interior; Rep. Gr. 68 ; Storage Compartments and Cov‐
ers; Driver Side Instrument Panel Cover, Removing and In‐
stalling .
– If installed, remove the driver side knee airbag. Refer to ⇒
Body Interior; Rep. Gr. 69 ; Knee Airbags; Overview - Knee
Airbag .
– Release and remove the expanding clip -3-.
– Remove the control module -1- rearward.
– Release and disconnect the connector -2-.
– To do this push the tab -1-, pivot the retaining bracket in the
direction of -arrow- and remove the connector.
Installing
Install in the reverse order of removal while paying attention to
the following:
Golf 2015 ➤ , Golf Variant 2015 ➤
Electrical Equipment - Edition 12.2015
11. Automatic Headlamp Range Control
211