Table of Contents
Advertisement
Category
Tools
Equipment
Materials
Figure 3-2: Tools and Materials Required for Assembly and Maintenance
3.3.
E
L E C TR I C AL
Before wiring the projector, refer to
stranded wire. Strip and tin the wire prior to connection. Use crimp connectors on all sound
connections. For projectors equipped with an automatic turret, refer to
3 . 3 . 1 . S
C
O L A R
Solar cell wiring requires a shielded, four-conductor audio cable. (red – left (+), black – left
(-), green – right (+), white – right (-)). The best signal-to-noise ratio is achieved by
maintaining the same ground potential between the soundhead and the cinema processor.
Refer to the directions in the sound system instruction manual for proper connection of the
sound system.
CHRISTIE INCORPORATED P35GPS Projector
June, 1998
Item
Miscellaneous Allen wrenches General Maintenance
Small standard screwdriver
Phillips screwdrivers
Oscilloscope
Voltmeter
Real-Time Analyzer
SK1994-3 alignment tool
P35-BT (SMPTE)
P35-FL
Cat 69 Loop
Cat 566 Loop
Cat 97 Loop
RP-40 Loop
C
O N N E C TI O N S
Figure 3-3
W
E L L
I R I N G
3 : P r o j e c t o r I n s t a l l a t i o n a n d A s s e m b l y
Soundhead Alignment
Lateral Guide Alignment
Buzz Track Test Loop
Flutter Loop
Dolby Tone, Pink Noise
Illumination Uniformity
Left/Right Alignment
Optical Alignment
for the wiring interface diagram. Use
Use
Section
6.6.3.
3-3
Advertisement
Table of Contents
