Removing The Diskette Drive Cable Assembly - Sun Microsystems Ultra 80 Service Manual

c. Connect the peripheral power cable to the chassis clips.
3. Detach the antistatic wrist strap.
4. Replace the access panel and power on the system.
See Section 6.3 "Replacing the Access Panel/Powering On the System" on page 6-6.
7.4.3

Removing the Diskette Drive Cable Assembly

1. Power off the system and remove the access panel.
See Section 6.1 "Powering Off the System/Removing the Access Panel" on page 6-1.
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
2. Attach the antistatic wrist strap.
See Section 6.2 "Attaching the Antistatic Wrist Strap" on page 6-5.
3. Disconnect the diskette drive cable assembly as follows (
a. Disconnect the diskette drive cable assembly from the hard drive cage SCSI
assembly connector.
b. Disconnect the diskette drive cable assembly from the rear of the diskette
drive.
4. Remove the diskette drive cable assembly.
):
FIGURE 7-6
Chapter -11