Removing The Diskette Drive Cable Assembly; Figure - Sun Microsystems Ultra 2 series Service Manual

b. Connect the following:
P3 connector to J1203 on the motherboard.
P1 connector to J1202 on the motherboard.
P2 connector to the CD-ROM drive (or 4-mm/8-mm tape drive).
2. Detach the wrist strap.
3. Replace the system unit cover.
See Section 7.3 "Replacing the System Unit Cover" on page 7-4.
4. Power on the system unit.
See Section 6.1 "Powering On the System Unit" on page 6-1.
8.2.3

Removing the Diskette Drive Cable Assembly

1. Power off the system unit.
See Section 6.2 "Powering Off the System Unit" on page 6-2.
2. Remove the system unit cover.
See Section 7.1 "Removing the System Unit Cover" on page 7-1.
Caution –
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing it on any surface.
3. Attach the wrist strap.
See Section 7.2 "Attaching the Wrist Strap" on page 7-3.
4. Disconnect the following (
a. P2 connector from the rear of the diskette drive.
b. P1 connector from J1201 on the motherboard.
5. Remove the diskette drive cable.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Use proper ESD grounding techniques when handling components. Wear

FIGURE 8-4

: