Removing The Diskette Drive - Sun Microsystems SPARC classic Service Manual

9.3.1

Removing the Diskette Drive

To remove the diskette drive:
1. Preparation.
Follow the instructions for removing the disk drive mounting bracket in Section 9.2.1
"Removing the Disk Drive Mounting Bracket.
2. Remove the four Phillips-head screws holding the diskette drive to the disk drive
mounting bracket (see
3. Remove the diskette drive from the bracket.
Slide the diskette drive out of the bracket as shown in
antistatic mat.
Diskette drive
FIGURE 9-16
4. Detach the diskette drive data cable.
Detach the data cable from the diskette drive and set it aside for use with the
replacement drive.
9-22 SPARCclassic/SPARCclassic X/SPARCstation LX Service Manual • November 1993
FIGURE 9-16
Screw holes
Drive select switch
(hidden from view)
Disk Drive Mounting Bracket
).
FIGURE 9-16
Diskette drive power cable
Diskette drive data cable
Pull tab
Captive screw
Drive mounting bracket
and place it on an
Screw holes
Thread data cable
through this opening
in top of bracket.