Figure 5-39 Location Of The Mounting Screws - Sun Microsystems Sun Fire V60x Manual

13. Remove the eight screws that secure the processor retention mechanisms and the
three mounting screws that secure the server board to the chassis (see Figure 5-39).
Caution – Make sure that all 11 screws have been removed before attempting to
take out the board. Do not use any tools to try to pry the board out of the server.
Attempting to do this could result in severe damage to the board.
Location of the Mounting Screws
FIGURE 5-39
14. Slide the board toward the front of the chassis until the I/O connectors are clear of
the chassis I/O openings, lift the server board from the chassis, and place it on an
antistatic pad.
15. Remove the replacement server board from its packaging and antistatic bag.
16. Ensure that the Mylar insulator sheet is seated securely over the standoffs, is
laying flat on the chassis floor, and that the edge of the sheet is seated below the
studs in the rear chassis wall.
17. Insert the back edge of the board under the three retention pins located at the rear
of the chassis.
18. While placing the board on the chassis standoffs, carefully align the board I/O
connectors with the rear chassis I/O openings.
19. Adjust the board's position so that the three mounting holes rest securely on the
shouldered standoffs.
Chapter 5 Maintaining the Server 5-59