Figure 5-6 Dimm Pair Locations - Sun Microsystems Sun Fire V60x Manual

Figure 5-6 shows how the DIMM pairs are to be installed. They must be installed in
pairs. There are three banks of DIMMs, labeled 1, 2, and 3. Bank 1 contains DIMM
locations 1A and 1B, Bank 2 contains 2A and 2B, and Bank 3 contains 3A and 3B.
DIMM socket identifiers are marked on the silkscreen next to each DIMM socket on
the baseboard. Note that the sockets associated with any given bank are located next
to each other.
Fault LEDs
FIGURE 5-6
Note – The Comprehensive Test should be run after changing any FRU, CRU, or
adding an optional component. See "Run Platform Confidence Test (PCT)" on
page 4-31.
5-12 Sun Fire V60x and Sun Fire V65x Servers—Troubleshooting Guide • November 2003
Back of Main Board
J5F1 J5F2 J5F3 J6F1
1B 1A 2B
2A
Bank 1 Bank 2
Front of Main Board
DIMM Pair Locations
J6F2
J6F3
3B 3A
Bank 3