Floppy/Dvd/Cd-Rom Combo Module - Sun Microsystems Sun Fire V60x Manual

5.5.2

Floppy/DVD/CD-ROM Combo Module

Caution – A floppy/DVD/CD-ROM module is NOT hot swappable. Before
replacing it, you must first take the server out of service, turn off all peripheral
devices connected to the system, turn off the system by pressing the power button,
and unplug the AC power cord from the system or wall outlet.
Note – In the Sun Fire V60x server, the floppy/DVD/CD-ROM module may be
replaced with a hard disk drive. If you do this, you need to install a small plastic
cover to cover the gap at the right side of the drive that is left by removal of the
(larger size) floppy/CD-ROM module. The plastic cover is included in the accessory
kit.
To replace the Floppy/CD-ROM module, follow these steps:
1. Before removing the cover to work inside the system, observe the safety
guidelines previously stated.
2. Remove the bezel from the front of the chassis.
3. As shown in Figure 5-4, rotate the module's handle bar up (A) and pull on the
handle bar to remove the module from the flex bay.
4. Slide a new module into the flex bay until you feel the connectors touch.
5. Push the module in (using the handle bar) about 3/16 of an inch (5mm) more to
fully engage the connectors.
6. Rotate the handle bar down.
7. Reinstall the bezel.
Chapter 5 Maintaining the Server 5-7