5.5.13
Emergency Management Port Cable
Two different serial port adapters may be installed into the rear panel RJ-45 Serial
COM2 Emergency Management Port (EMP) connector:
DSR Peripherals Cable
■
DCD Modem Cable
■
5.5.13.1
Installing the DSR Peripherals Cable
Follow these steps to install the DSR Peripherals cable:
1. Plug the DSR Peripherals cable into the rear panel RJ-45 Serial COM2 connector
as shown in Figure 5-37.
2. Configure the J5A2 jumper as shown in Figure 5-37.
5.5.13.2
Installing the DCD Modem Cable
Follow these steps to install the DCD Modem cable:
1. Plug the DCD Modem cable into the rear panel RJ-45 Serial COM2 connector as
shown in Figure 5-37.
2. Configure the J5A2 jumper as shown in Figure 5-37.
5-52
Sun Fire V60x and Sun Fire V65x Servers—Troubleshooting Guide • November 2003