Booting Up; Figure 4-5 Location Of Clear Cmos Jumper - Sun Microsystems Sun Fire V60x Manual

N N
Location of Clear CMOS Jumper
FIGURE 4-5
4.5

Booting Up

As soon as power is applied to the server, the bootup process begins. Boot messages
are sent to either a monitor attached to the video port, or to a serial console attached
to the rear RJ-45 serial COM2 port.
The server is configured by default to initially send BIOS and kernel messages to
both the serial port and the video port. However, when the boot process reaches the
OS load point, the messages and screens are sent only to the video port. After
bootup is finished, the configuration can be changed to send all messages to the
serial console (see "Configuring an External Serial Console" on page 4-17).
Note – The USB ports may be disabled until the OS is booted and the USB drivers
are installed. A PS/2 keyboard is required if a keyboard is necessary for initial
bootup and configuration.
4-8 Sun Fire V60x and Sun Fire V65x Servers—Troubleshooting Guide • November 2003
I
2 4 6
J5A2
1 3 5
3-4 = DSR
1-2 = DCD
1
Recover
2
Normal RCVR\BOOT
3
4
5
Clear
6
CLR\PSWD
Normal
7
8
9
Clear
10 CLR\CMOS
Normal
11
1
Write En
2
Normal BMC BB WE
3