5.5.8.2
Sun Fire V60x Server Air Baffle Installation
Follow these steps to install the air baffle:
1. Ensure the flex cable, auxiliary power cable, USB ribbon cable, and SCSI cables
are routed under where you will be installing the air baffle.
FIGURE 5-30
2. Aligning pin (C) with the board's mounting hole, position the air baffle over the
white server board power connector.
3. Lower the baffle into position and press it down against the backplane board.
4. Ensure tab (A) aligns with the edge of the power supply and tab (B) aligns with
the edge of the fan module.
2
A
C
Installing the Air Baffle
B
Chapter 5 Maintaining the Server
5-39