Figure 4-20 Reboot Prompt - Sun Microsystems Sun Fire V60x Manual

To disable the Platform Event Filter:
1. Reset or turn on the server.
2. Press the F2 key to select SETUP as soon as the option appears on the screen.
3. Select the Server menu on the SETUP screen.
4. Check to see if the Platform Event Filter is disabled.
If the Platform Event Filter is disabled, it will not appear as an option in the
■
Server screen.
If the Platform Event Filter is enabled, go to Step 4.
■
5. To disable the Platform Event Filter, select Platform Event Filter from the Server
setup screen, press Enter, and select the Disable option.
6. Press the F10 function key to exit the SETUP menu and save changes.
Running the Platform Confidence Test
To run this test:
1. Select Run Platform Confidence Test (reboot required) on the System Utilities
submenu.
The prompt shown in Figure 4-20 is displayed:
FIGURE 4-20
Note – After the PCT is finished, you can view the results of the tests. However, the
system will be rebooted to the service partition after you finish PCT.
2. Press any key to bring up the warning screen shown Figure 4-21.
Note that it is advisable to save the System Event Log to a floppy before running the
PCT and that it is recommended that testing not be interrupted during the hardware
probe or during the BMC test.
4-32 Sun Fire V60x and Sun Fire V65x Servers—Troubleshooting Guide • November 2003
Reboot Prompt