Table 4-1 Jumper Function Summary - Sun Microsystems Sun Fire V60x Manual

Jumper Function Summary
TABLE 4-1
Designator Jumper Name
J5A2 RJ-45 Serial COM2 Port
Configuration
CLR\CMOS Clear CMOS
CLR\PSWD Clear Password
RCVR\BOOT BIOS Boot Recovery
BMC BB WE BMC Boot Block Write
Enable
Action at System Reset
Configures either a DSR or a DCD signal to the connector. See
"Rear Panel RJ-45 Serial COM2 Connector" in Chapter 2 of the
Sun Fire V60x and Sun Fire V65x Server User Guide and "Setting
the Serial COM2 Port Jumper" on page 4-4 of this document.
If these pins are jumpered, the CMOS settings are cleared. These
pins should not be jumpered for normal operation.
If these pins are jumpered, the password is cleared. These pins
should not be jumpered for normal operation.
If these pins are jumpered, the system will attempt BIOS
recovery. These pins should not be jumpered for normal
operation.
If these pins are jumpered, BMC boot block is erasable and
programmable at next reset. These pins should not be jumpered
for normal operation.
Chapter 4 Powering On and Configuring the Server 4-3