Table of Contents
Advertisement
Inter-Tel EncoreCX
Installation & Maintenance Manual
6.
Select "Incoming Calls Only".
7.
Select the lines that are to be used for incoming calls only. Lines programmed for incoming calls only will be
indicated by a "♦".
Press the speakerphone key to finish programming.
Incoming Calls Only when a T1/PRI Module is Installed and Programmed as T1 (RBS)
If the T1 lines are programmed as E&M, Loop Start or Ground Start then all the lines programmed as equipped
are shown when "Incoming Calls Only" is selected. See page 101.
1.
From the Programming extension, press the PROGRAM key.
2.
Press the Scroll Down key (î) until "System Programming" is displayed.
3.
Select "System Programming".
4.
Enter the System Programming Password and select "Lines".
5.
Press the Scroll Down key (î) until "Incoming Calls Only" is displayed.
6.
Select "Incoming Calls Only" option.
7.
The menu updates to show all relevant T1 lines as Line 1 – Line 24.
8.
If any CO Lines are installed they are shown as Line 25 – Line 28.
9.
Select the required lines to be reserved for incoming calls only.
The default setting is that no lines are programmed.
NOTE: Any T1 lines programmed as DID are not shown when the lines are displayed. DID channels are
incoming only and cannot be selected to make calls.
Incoming Calls Only when a T1/PRI is installed and Programmed as PRI (ISDN)
The PRI (ISDN) B channels programmed as equipped can be programmed so that they are reserved for incoming
calls only. The same applies to any additional CO Lines equipped.
From the Programming extension, press the PROGRAM key.
1.
Press the Scroll Down key (î) until "System Programming" is displayed.
2.
Select "System Programming".
3.
Enter the System Programming Password and select "Lines".
4.
Press the Scroll Down key (î) until "Incoming Calls Only" is displayed.
5.
Select "Incoming Calls Only" option.
6.
The menu updates to show all B channels and the back up CO lines
7.
Select the required lines to be reserved for incoming calls only.
The default setting is that no lines are programmed.
If a user selects a Line key of a line that is set as Incoming only, busy tone is returned and the message
'Restricted' is shown on the display.
Outgoing Groups
Line Selection Method
Two different ways of selecting a line, when the line access codes are used, are provided.
Linear Outgoing Line Group: - Requests for an outgoing line are always processed beginning with the highest
numbered line in the group and moving down the list until an available line is found. This is the default setting
for all outgoing groups.
Distributed Outgoing Line Group: The first request will be processed beginning with the highest numbered line
in the group. The next request will begin with the second line, and each subsequent request will begin one line
lower in the group. When the end of the list is reached, requests begin again with the highest numbered line in the
group.
This method applies to switches equipped with CO Lines, T1 (RBS) channels and PRI B-channels. In cases
where CO Lines are provided as well as T1 or PRI, the CO Lines are selected only when all the T1 or PRI
channels are busy.
104
Hide quick links:
Advertisement
Table of Contents
