Did Line Type - Service Types; Loop Start Line Type - Service Types; Ground Start Line Type - Service Types; Programming The Start Types - Inter-Tel EncoreCX Installation And Maintenance Manual

Inter-Tel EncoreCX
Installation & Maintenance Manual

DID Line Type - Service Types

For DID Line Types the following options are available: -
None - No Service Type is set.
ANI
DNIS
*ANI*
*DNIS*
*ANI*DNIS*
1. From the programming extension, press the PROGRAM key.
2. Press the Scroll Down key (î) until "System Programming" is displayed.
3. Select "System Programming".
4. Enter the System Programming Password and select "Lines".
5. Press the Scroll Down key (î) until "T1 (RBS) or PRI (ISDN)" is displayed.
6. Select T1 (RBS).
7. Select "Line Type".
8. Select "DID" line type.
9. Select one of the options listed above.
The default setting is "None".

Loop Start Line Type - Service Types

For Loop Start Line types the following options are available: -
None - No Service Type is set.
Caller ID.
1. From the programming extension, press the PROGRAM key.
2. Press the Scroll Down key (î) until "System Programming" is displayed.
3. Select "System Programming".
4. Enter the System Programming Password and select "Lines".
5. Press the Scroll Down key (î) until "T1 (RBS) or PRI (ISDN)" is displayed.
6. Select T1 (RBS).
7. Select "Line Type"
8. Select "Loop Start" line type.
9. Select one of the options listed above.
The default setting is that no service type is set.

Ground Start Line Type - Service Types

If Ground Start is selected no additional menu is presented. There are no services available on Ground Start lines.

Programming the Start Types

The start types can be set as Immediate, Wink, Delay Dial or Dial Tone depending on the line type.
E&M Start Types
When E&M Service Type is selected four Start Types are available.
Immediate.
Wink.
Delay Dial.
Dial Tone.
1. Enter the System Programming Password and select "Lines".
2. Press the Scroll Down key (î) until "T1 (RBS) or PRI (ISDN)" is displayed.
3. Select T1 (RBS).
4. Select "E&M".
5. Select the service type.
6. The list of Start Types is presented, select the required Start Type. (Default setting is Wink Start)
DID Start Types
When DID Service Type is selected three Start Types are available.
112