Table of Contents
Advertisement
Immediate.
Wink.
Dial Tone.
1.
Enter the System Programming Password and select "Lines".
2.
Press the Scroll Down key (î) until "T1 (RBS) or PRI (ISDN)" is displayed.
3.
Select T1 (RBS).
4.
Select "DID".
5.
Select service type.
6.
Select one of the options from the above list.
The default setting is Wink Start.
Programming Received Digits on the T1
If Received digits is selected the display updates to show the equipped T1 lines.
1.
From the programming extension, press the PROGRAM key.
2.
Press the Scroll Down key (î) until "System Programming" is displayed.
3.
Select "System Programming".
4.
Enter the System Programming Password and select "Lines".
5.
Press the Scroll Down key (î) until "T1 (RBS) or PRI (ISDN)" is displayed.
6.
Select T1 (RBS).
7.
Select "Received Digits".
8.
The menu displays all the equipped lines.
9.
Select the required line.
When a line is selected the display shows the current setting for 2 seconds.
After the 2 seconds the programming range is shown on the top line of the display.
Up to 32 digits can be received between ANI and DNIS. The default setting is 2 digits.
Programming the Line Gain on T1 (RBS)
The Line gain can be adjusted for each T1 (RBS) channel.
If Line Gain is selected the menu updates to show the T1 lines.
1.
From the programming extension, press the PROGRAM key.
2.
Press the Scroll Down key (î) until "System Programming" is displayed.
3.
Select "System Programming".
4.
Enter the System Programming Password and select "Lines".
5.
Press the Scroll Down key (î) until "T1 (RBS) or PRI (ISDN)" is displayed.
6.
Select T1 (RBS).
7.
Select "Line Gain".
8.
The menu displays all the equipped lines.
9.
Select the required line.
10. The menu updates to show the options available.
11. Select either "Low", "Medium" or "High". A solid diamond indicates the current setting.
The default is that all lines are set to high -3dB.
Programming DTMF/Pulse Dialing on the T1
Either DTMF of Pulse Dialing can be selected for the T1 channels.
1.
From the programming extension, press the PROGRAM key.
2.
Press the Scroll Down key (î) until "System Progra mming" is displayed.
3.
Select "System Programming".
4.
Enter the System Programming Password and select "Lines".
5.
Press the Scroll Down key (î) until "T1 (RBS) or PRI (ISDN)" is displayed.
6.
Select T1 (RBS).
7.
Select "DTMF/Pulse Dialing".
8.
The menu displays the two options, "DTMF Dialing" or "Pulse Dialing".
9.
Select "DTMF Dialing" option.
The menu updates to show all the equipped lines.
10. Select the lines to set as DTMF Dialing.
Installation and Maintenance Manual
EncoreCX
113
Hide quick links:
Advertisement
Table of Contents
