Table of Contents
Advertisement
Power On
1. Ensure the power cord is attached to the receptacle on the rear of the CSL.
Note: The power cord and applicable interface cable (ESCON or SCSI) should
2. If the power cord is not attached to the CSL, do the following:
a. Attach the female end of the power cord to the CSL receptacle.
b. Attach the male end of the power cord to a power outlet.
3. Press the
4. Verify that the CSL powers on.
Note: A steady asterisk on the operator panel indicates a successful IPL
Power Off
1. Press the
2. Ask the operator to ensure that the drive has no I/O from the host.
Note: In the enterprise environment, have the operator vary the drive
3. Use the operator panel to place the CSL offline.
Note: Refer to
4. Press the
off the CSL.
5. Verify that the CSL powers off.
Note: All indicators are off and the operator panel is blank.
95739
have been attached during initial installation.
switch on the rear of the CSL to ON (1).
POWER
completion, the drive is online, but not loaded with a cartridge.
switch to eject the cartridge from the CSL.
Unload
offline.
Chapter 4, "Menus."
switch on the rear of the CSL to OFF (0). This will power
POWER
Ninth Edition
for instructions to place the CSL offline.
Power On/Off CSL
6-11
Advertisement
Table of Contents
