Table of Contents
Advertisement
Powering Off a Drive
To perform a power-off procedure, follow these steps:
Note: Refer to
1. Ensure that the 9840 Tape Drive is not selected from the host (see
in
Chapter 4,
2. Unload the cartridge tape from the drive.
3. Remove power from the drive or power supply:
a. If the drive or drive tray has a power switch on the back, turn the switch
b. For library attached drives, turn the power supply switch to OFF
c. If the library drive power supply does not have a power switch, unplug
WARNING:
Do not unplug the yellow and black power connector on a library
attached drive. The line is hot and you may be shocked if you touch bare
wires or pins.
95739
"Power On/Off CSL" in Chapter 6, "Cartridge Scratch Loader"
power off a CSL.
"Menus").
to OFF.
(Figure 3-1 on page
3-1).
the black-power cord from the power supply. See warning below.
Ninth Edition
Powering Off a Drive
to
"Offline"
3-7
Advertisement
Table of Contents
