Table of Contents
Advertisement
Reclaim Cartridge Tape
4. Press the
message.
5. Press the
If a cartridge tape is already in the 9840 Tape Drive, it ejects. The operator
panel displays the "LdDataTp" message.
6. Place a cartridge tape that is not write-protected into the 9840 Tape Drive.
The reclaim process starts automatically, and it erases and reformats the
tape. After the reclaim process completes, the cartridge tape ejects.
Note: If the operator panel displays the "DatCrFail1" message, see
7. Remove the ejected cartridge tape from the 9840 Tape Drive.
8. To reclaim another cartridge tape, repeat steps 6 and 7.
9. When you are finished reclaiming cartridge tapes, press the
until the operator panel displays the "Exit Drv?" message.
10. Press the
message.
11. Press the
12. Press the
13. Place the 9840 Tape Drive online (see
4-26
switch until the operator panel displays the "MakeDataTp"
Menu
switch to initiate the reclaim process.
Select
Chapter 5, "Drive Errors and Messages,"
switch until the operator panel displays the "Exit Menu?"
Menu
switch to repeat the operation or
Menu
switch to go to main exit menu
Menu
Ninth Edition
for corrective action.
Select
to exit the operation
Select
"Online" on page
4-22).
switch
95739
Advertisement
Table of Contents
