Csl Cartridge Loading/Unloading; Cartridge Loading; Figure 6-10. Cartridge Loading - StorageTek 9840 User's Reference Manual

CSL Cartridge Loading/Unloading

CSL Cartridge Loading/Unloading

This section contains procedures to load and unload cartridges within the CSL.

Cartridge Loading

Note: Engineering recommends no drive activity during cartridge loading. This
To correctly load a cartridge into the input bin, follow these instructions and
refer to
Notes:

Figure 6-10. Cartridge Loading

1. Move the CSL spring-loaded slider to the right and hold it in this position
while loading cartridges.
2. Load cartridges into the CSL vertically with the Media Id label (R) facing out
towards the operator (reels to the right).
3. Verify that the customer label (if used) is on the left side of the cartridge
(toward the feed channel).
4. Tilt the cartridge back slightly.
5. Insert the bottom-back edge of the cartridge into the CSL input bin.
6-12
ensures that no drive errors are induced.
Figure 6-10.
• Load cartridges into the CSL vertically with the Media Id label (R)
right side up and facing out towards the operator (reels to the right).
• Never load cartridges with the cartridge reels to the left.
• Never load cartridges flat within the CSL. This causes an instant CSL
failure.
Ninth Edition
CARTRIDGE
INPUT
REELS
BIN
SLIDER
C53358
95739