• In the VM/MVS environment: ESCON Swap
• In the SCSI environment: Recover Buffer Data
Shipping Insert
Note: Refer to
Follow these instructions to properly install and lock the shipping insert
(Figure
you must use the manual unload device (MUD) screw (step 2) to raise the reel
motors and to lower the cleaning brush within the drive.
Figure 5-2. Shipping Insert
CAUTION:
If the shipping insert is not locked into the tape drive, the drive head will
become damaged in shipment.
Notes:
95739
Chapter 6, "Cartridge Scratch Loader,"
shipping insert into a CSL.
5-2) into a drive. Before you can lock the shipping insert into the drive,
SHIPPING
INSERT
• Only use the MUD mechanism to reset the drive for shipping or to
remove jammed cartridges.
• The MUD screw must be turned to the left or counter-clockwise
(CCW) to reset the drive to its shipping position and to install and
lock the shipping insert into the drive.
• The MUD screw must be turned to the right or clockwise (CW) to
remove jammed cartridges.
Ninth Edition
Shipping Insert
to install and lock a
C53635
5-9