Evaluation Change Display - Sharp IV-S30J User Manual

Setting the Operating and System Conditions

[8] Evaluation change display

Specify whether the evaluation condition change
menu can be displayed on the operation screen or
not.
2
Select the "
RUN COND" screen and select "YES" on the popup
menu.
Press the TRG/BRT key to move the cursor to the
upper function menu. Select "SCREEN" and press the
SET key. Then select "OPS-MENU."
Select "SCREEN-CHG" on the lower menu on the
operation screen, and press the SET key. "JDG-
COND CHG" will be displayed in the lower right
corner of the screen. You can display the evaluation
condition change menu by pressing the up and down
keys.
- Press the SET key. The cursor will move to the
area containing the phrase "evaluation condition
change menu during operation." You can change
the settings for the evaluation conditions.
- At this time, the screen display will look the same
as the normal operation main screen, except for
the area marked "evaluation condition change
menu shown during operation."
DISP CHG-EVAL" line on the "TYPE
TYPE RUN COND SCREEN SAVE
1MONITOR OUTPUT
2CAPTURE IMG
3MESSAGE DISPLAY
4PATTERN DISPLAY
5SHOW BINARY IMG
6SHOW
FIX IMG
7OPS MAIN DISP
8DISP CHG-EVAL
9PC-MNTR
0THROUGH DISPLAY
qEXTENSION FUNC.
SET=SELECT A MENU ESC=BACK SEL=CHNG IMG TRG=FUNC
TYPE RUN COND SCREEN SAVE
1MONITOR OUTPUT
2CAPTURE IMG
3MESSAGE DISPLAY
4PATTERN DISPLAY
5SHOW BINARY IMG
6SHOW
FIX IMG
7OPS MAIN DISP
8DISP CHG-EVAL
9PC-MNTR
0THROUGH DISPLAY
qEXTENSION FUNC.
(TYPE00)
MEAS 0000ms
MEASURE 0 CAM1 NO
Display evaluation condition
change menu while in operation
MNU-CHG MAIN-COND CHG-MEA COND-CHG CHNG-REG SCREEN-CHG CHG-TYPE
2-10
F C1 BRT
CAM1
PARTIAL-IMG
YES(NUMERIC)
YES
YES
YES
YES
YES
YES
NO
NO
NO
NO
F C1 BRT
CAM1
OPS-MENU
PARTIAL-IMG
MAIN
YES(NUMERIC)
SELECT
YES
RETURN
YES
YES
YES
NO
NO
NO
NO
F C1 BRT
JDG-COND-CHG
PC-MNTR