Setting Operation; Setting Examples - Sharp IV-S30J User Manual

Lead Inspection

6-2 Setting operation

Setting the measurement conditions
How to enter the measurement conditions setting screen
Select "MAIN-COND" -> "OBJECT TYPE
COND" -> "TYPE00" ->"MEA-CND (CAM-
ERA1) " -> "MEAS(NEW)," in that order. Then
press the SET key to bring up the "MEAS1"
screen.
6
Move to the "
the "MEASUREMENT1" screen and select
"INSPECT-LEAD" from the popup menu.
Press the ESC key to return to the "OBJECT TYPE COND" (menu tree) screen, and select the
"MEAS CND" item shown under "MEAS01 (INSPECT-LEAD)" to go to the "MEAS CND" screen.
For details, see "Chapter 8: Setting Examples Using the Menu Tree" in Introduction and
Hardware.
MEAS SELECTION" line on
6-2
SELECT OBJECT TYPE COND
OBJECT TYPE COND
TYPE00
TYPE RUN COND
IMAGE-ADJ
MEA-CND(CAMERA1)
MEAS0
POSI-CORRECT
MEAS(NEW)
+ +
MEA-CND(CAMERA2)
FINAL NUM. CALC
FINAL OUTPUT COND
OBJ-TYPE I/0
OBJ-TYPE SYS.
TYPE(NEW)
=WINDOW SET ESC=BACK SEL=CHNG IMG TRG=POPUP
MEASUREMENT1 SCREEN COND SAVE
1MEAS SELECTION
INSPECT-LEAD
=SELECT A MENU ESC=BACK SEL=CHNG IMG TRG=FUNC
F C1 BRT
1MEAS SELECTION
F C1 BRT
NO
POSI-DEVIATION
CHK-DEG-MATCH
INSPECT-LEAD
MEAS-BIN-AREA
CNT-BIN-OBJ
LABEL-BIN-OBJ
POINT-MEAS
MULTI-POSI
MULTI MATCHES