Setting Examples - Sharp IV-S30J User Manual

14-4 Setting examples

The example below shows the settings used to evaluate and output the X-Y coordinates (differences)
of the detection points in images 0 and 1, using the evaluation calculation. (Degree of match
inspection See Chapter 5: Output
Point detected in image 0
(register number 00, model 0)
(1) Image setting
After specifying the images, return to the "MEA CND" screen for the degree of match inspection.
(2) Operations on the "MEA CND" screen
Press the TRG/BRT key to move the cursor to the
upper function menu. Select "COND" and press
the SET key. Select "NUM-CALC" from the popup
menu and then press the SET key.
(3) Operations on the "NUMERIC CALC" screen
1. Select position "A" (2nd cell in the "TYPE"
column) on the "N00" line using the up and
down arrow keys. Select "CRD-X" from the
popup menu and then press the SET key.
2. Move the cursor to position "B" (2nd cell in the
"FORMULA" column) and press the SET key.
"00X0" will be displayed in the "FORMULA"
column. Select a digit using the left and right
arrow keys. Press the SET key. Then change
the selected digit "01X0" by using the up and
down keys.
X
"01X0" is referring to the X coordinate of
register number 01 (image 1) and model 0.
See Chapter 15: PC Function.)
Image 0
X coordinate difference
Y coordinate difference
Object to be measured
Point detected in image 1
(register number 01, model 0)
Image 1
MEA CND SCREEN COND SAVE
1DTECT PRECISION STANDARD
2REGISTER NO.
00(0~15)
3MODE
1P-SCH
4SEARCH
YES
5MATCHING
AVG-GRAYS
REGISTER NO.
6MDL 0
7MDL 1
SET=SELECT A MENU ESC=BACK SEL=CHNG IMG TRG=FUNC
NUMERIC CALC SCREEN COND SAVE
[N00-N07]
CHG-CALC
1RUN A TEST
(SET KEY)
TYPE FORMULA
MATCH M
CRD-X
CRD-Y
LVL G
NUM-CAL[NC]
CNST[C]
NO
SET=EXEC ESC=BACK SEL=CHNG IMG TRG=FUNC
14-11
Numerical Calculations
F C1 BRT
IMG PRE-PROC
REG COND
EVALUATION
DST&ANGL
NUM-CALC
OUT
F C1 BRT
OBJECT TYPE
CALC RESULT
CNST
SUM
AVG
CBP
CBM
DEL
14