Sharp IV-S30J User Manual page 137

Object Identification by Binary Conversion
AX.ANGL (axis angle)
Select whether to measure the angle of the longitudinal line
(drawn through the gravity center of the workpiece) to the
horizontal.
FILT (fillet diameter)
Select whether to measure the diameters of horizontal and
vertical fillets on the workpiece.
CIRC-L (peripheral length)
Select whether to count the number of pixels in the
perimeter of the workpiece.
MID-PNT
(middle point)
9
Select whether
to measure the
center point of
the workpiece.
REGISTER NO. (
Register setting conditions are shown for each register number. Circles mean that "REGISTER
EXIST" has set to "YES."
Æ Setting (display) of binary area conditions
REGISTER NO.
0BIN AREA COND
Center of gravity, main axis angle, and center
X1
(0, 0)
Y
Vertical
fillet
diameter
Horizontal fillet
diameter
By the combined use of the center point and the center of gravity, a workpiece'
orientation can be measured even when it cannot be evaluated by its spindle axis
BIN AREA COND)
No setting
9-4
Main axis angle
Fillet width
Fillet width (horizontal)
Peripheral
The number of pixels in
the boundary line of an
object
(stepped are counted as
x 2 pixels)
Center of gravity (X1, Y1)
- Calculated from the area and the position of each object.
- (X1, Y1)=( x/N, y/N) N: Area
Main axis angle
- Angle between the longitudinal and horizontal directions
(511, 479)
The "MID-PNT" refers to the center point of
horizontal or vertical fillet curves.
Gravity
Gravity center
center
Spindle
Spindle
axis
axis
angle
angle
When item "4REGISTER EXIST" is
set to "YES," a circle is displayed.
Gravity center
Main axis angle
Center point