Operation Main Display - Sharp IV-S30J User Manual

[7] Operation main display

When the operation screen was set to display other
screens (such as the "DISP CHG-EVAL" and "PC-
MNTR" screens), this item should be selected to return
to the main display from other screens. On the "TYPE
RUN COND" screen, select "
then "YES" on the popup menu. That will return you to
the main operation screen.
Note: When other screens are set to "YES" (such as
the " DISP CHG-EVAL" and "
screens), make sure to select "YES" from the
OPS MAIN DISP.
Press the TRG/BRT key to move the cursor to the
upper function menu. Select "SCREEN" and press the
SET key. Then select "OPS-MENU."
Select "SCREEN-CHG" on the lower menu on the
operation screen and press the SET key. "OPS-MAIN"
will be displayed in the lower right corner of the screen.
While the "OPS-MAIN" line is highlighted, press the
SET key. The main display will then change back to the
operation screen from the other screens (e.g. the JDG-
COND-CHG and PC-MNTR screens).
Setting the Operating and System Conditions
TYPE RUN COND SCREEN SAVE
1MONITOR OUTPUT
2CAPTURE IMG
3MESSAGE DISPLAY
OPS MAIN DISP" and
4PATTERN DISPLAY
5SHOW BINARY IMG
6SHOW
7OPS MAIN DISP
8DISP CHG-EVAL
9PC-MNTR
PC-MNTR"
0THROUGH DISPLAY
qEXTENSION FUNC.
SET=SELECT A MENU ESC=BACK SEL=CHNG IMG TRG=FUNC
TYPE RUN COND SCREEN SAVE
1MONITOR OUTPUT
2CAPTURE IMG
3MESSAGE DISPLAY
4PATTERN DISPLAY
5SHOW BINARY IMG
6SHOW
7OPS MAIN DISP
8DISP CHG-EVAL
9PC-MNTR
0THROUGH DISPLAY
qEXTENSION FUNC.
MNU-CHG MAIN-COND CHG-MEA COND-CHG CHNG-REG SCREEN-CHG CHG-TYPE
2-9
CAM1
PARTIAL-IMG
YES(NUMERIC)
YES
YES
FIX IMG YES
YES YES
NO NO
NO
NO
NO
CAM1
PARTIAL-IMG
YES(NUMERIC)
YES
YES
FIX IMG YES
YES
NO
NO
NO
NO
(TYPE00) AREA1
MEAS ms
MEASURE 0 CAM1 POSI-DEVIATION
F C1 BRT
2
F C1 BRT
OPS-MENU
MAIN
SELECT
RETURN
F C1 DRK
V*.**
C1=002.2 OK
C2=100.0 OK
OPS-MAIN
PC-MNTR