Sharp IV-S30J User Manual page 120

Area Measurement by Binary Conversion
How to set the register conditions
How to enter the REG-COND setting screen
There are three methods for getting to the REG-COND setting screen.
1) On the "MEA-CND" setting screen, move the
cursor to the "
press the SET key. The cursor will move into
the table. Move the cursor to the " " column
and press the SET key.
Note: If you press the SET key in the "X"
2) On the "MEA-CND" setting screen, press the
TRG/BRT key to move the cursor to the upper
function menu. Select the "COND" item and
then select the "REG COND" item and press
the SET key.
7
3) On the menu tree, move the cursor to the
"MEAS CND" item, and press the right arrow
key. The sub menu which contains the "REG
COND" item will appear. Move the cursor to
this item and press the SET key.
Set the register conditions
REGISTER NO.
The currently selected register number is
displayed.
If you want to set the measurement conditions
for a different register number, press the SET
key to highlight the register number currently
selected. Then press the up and down arrow
keys to select the register number whose
measurement conditions you want to set.
Press the SET key to confirm your selection.
Note: When the "BINARY-IMG-MASK" or the
BIN AREA COND" and
column, the setting will be invalid.
"POLYGON" is selected at
" WINDOW" on the "MEA-CND"
screen, the " REGISTER NO." line
will not be displayed and the other item
numbers are decrement by one since
the register number for "BINARY-IMG-
MASK" and "POLYGON" is fixed.
MEA-CND SCREEN COND SAVE
1
NUM-OF-MASK
2REGISTER NO.
00(0 15)
3REGISTER EXIST NO
REGISTER NO.
4BIN AREA COND
SELECT OBJECT TYPE COND
OBJECT TYPE COND
TYPE00
TYPE01
TYPE RUN COND
IMAGE-ADJ
MEA-CND(CAMERA1)
MEAS0
POSI-DEVIATION
MEAS01(MEAS-BIN-AREA)
MEAS(NEW)
MEA-CND(CAMERA2)
FINAL NUM. CALC
FINAL OUTPUT COND
OBJ-TYPE I/O
OBJ-TYPE SYS.
SET=TO NEXT SUB-MENU ESC=BACK SEL=CHNG IMG TRG=POPUP
REG COND SCREEN COND SAVE DETAIL
1REGISTER NO.
2MEAS SHAPE
RECTANGLE
3MEAS AREA
SET (224,208) (287,271)
4THRESHOLD
SET [U.LM255 L.LM100 (0~255)]
5INVERT B/W
NO
SET=VALUE INPUT ESC=BACK SEL=CHNG IMG TRG=FUNC
7-4
F C1 BRT
IMG PRE-PROC
REG COND
EVALUATION
NUM-CALC
OUT
F C1 BRT
1REGISTER NO.
2MEAS SHAPE
3MEAS AREA
4THRESHOLD
5INVERT B/W
IMG PRE-PROC
MEAS CND
REG-COND
EVALUATION COND
NUM-CALC
OUT-COND
F C1 BRT