Setting (Operating) Procedure - Sharp IV-S30J User Manual

Setting the Input/Output Conditions
(2) When the measurement is started by a CCD trigger or a parallel I/F signal and the results are
output by a general purpose serial I/F signal
When the IV-S30J responds, data in a specified block is output after the output data (block 0) from the
measurement No. 0 to 4, in response to the measurement run command 2 (processing code 11
Response
: 1 1
Measurement 0
Camera 1
data 2
See page 17-7 for details about
Note: The response returned by the measurement run command 2 (processing code 11
contain the specified block.

[2] Setting (operating) procedure

Setting (operating) procedure
1. Select "MAIN COND" -> "OBJECT TYPE
COND" -> "TYPE00" -> "OBJ-TYPE I/O" in
that order.
2. The "OBJ-TYPE I/O" screen will appear. Move
the cursor to "
the SET key. A popup menu will appear.
Select "BLOCK-ASSIGN" and press the SET
key.
16
Object Output evaluation
type results
RC RC
Y0 Y1
(H) (L)
Data from
measurement 1
Camera 2
data 2
data 2
SERIAL OUTPUT" and press
1
Measurement 0
Camera 1 Camera 2
Y15
Data from Data from
measurement 2 measurement 3
data 2 data 2
and .
SELECT OBJECT TYPE COND
OBJECT TYPE COND
TYPE00
TYPE RUN COND
IMAGE-ADJ
MEA-CND(CAMERA1)
MEA-CND(CAMERA2)
FINAL NUM.CALC
FINAL OUTPUT COND
OBJ-TYPE I/O
OBJ-TYPE SYS.
TYPE(NEW)
SET=TO NEXT SUB-MENU ESC=BACK SEL=CHNG IMG TRG=POPUP
OBJ-TYPE I/O SCREEN SAVE
1TRIG CCD START
2
3
4
5
6
SET=SELECT A MENU ESC=BACK SEL=CHNG IMG TRG=FUNC
16-24
Data from Data in the
measurement 4 specified
data 2
block
1TRIG CCD START
2CCD TRIG COND
3
4
5
6
7
8
NO
1/00060(1/30~1/10000)
1(1~2)
).
(H)
SC SC CR
(H) (L)
) will not
(H)
F C1 BRT
F C1 BRT