Sharp IV-S30J User Manual page 146

Existence Inspection by Point Measurement
POINT COND
Points which have been registered are marked with an "O."
- After being registered on the point condition setting screen, an "O" will be displayed in the
corresponding cells.
For details, see next page.
Setting the conditions (by selecting the point conditions)
How to enter the REG COND setting screen
This paragraph describes the setting for each point condition.
There are three ways to bring up the "REG COND" screen.
1) On the "MEA-CND" setting screen, move the
cursor to the "
the SET key. The cursor will move into the
table. Move the cursor to the "X" column and
press the SET key.
Note: After being registered, the "X" mark in a
2) On the "MEA-CND" setting screen, press the
TRG/BRT key to move the cursor to the
upper function menu. Select the "COND" item
and then select the "REG COND" item and
press the SET key.
10
3) On the menu tree, move the cursor to the
"MEAS CND" item, and press the right arrow
key. The sub menu which contains the "REG
COND" item will appear. Move the cursor to
this item and press the SET key.
POINT COND" and press
corresponding cell is changed to "O."
MEA-CND SCREEN COND SAVE
1
2BINARY PROCESS
3THRESHOLD
4
5
SET=
SELECT OBJECT TYPE COND
OBJECT TYPE COND
TYPE00
TYPE RUN COND
IMAGE-ADJ
MEA-CND(CAMERA1)
MEAS01(POINT-MEAS)
POSI-CORRECT
MEAS(NEW)
MEA-CND(CAMERA2)
FINAL NUM. CALC
FINAL OUTPUT COND
OBJ-TYPE I/O
OBJ-TYPE SYS.
SET=TO NEXT SUB-MENU ESC=BACK SEL=CHNG IMG TRG=POPUP
10-4
F C1 DRK
IMG PRE-PROC
FIXED REG COND
SET [U.LM255 L.LM100(0~255)]
EVALUATION
NUM-CALC
OUT
F C1 BRT
1SIZE
2EVALUATION
3EVAL-SPEC(RATIO %)
4REGISTER NO.
IMG PRE-PROC
MEAS CND
REG-COND
EVALUATION COND
NUM-CALC
OUT-COND