Sharp IV-S30J User Manual page 28

Setting and Operating Outline
From the previous page
1
Determining the measuring time (timer stop)
Parallel output (Y0 to Y15) OFF
External interface enabled (communications)
No Computer link
Serial output
General purpose
General purpose serial output Computer link output
External interface enabled (key, parallel)
*3 Set the measurement
start input to any choice
No
*3
other than "parallel" or
set the 'READY' ON
Yes
signal to "end
measurement."
READY ON
Waiting for a measurement start input signal or a key input
- When the halt NG measurement option is set to "YES" (page 3-38), the controller stops measuring
when an error occurs.
1-21